| Model DT-1010 Dual-Blade Sample Cutter
The Model DT-1010 (shown at left) is designed to cut sample strips of uniform width, with precise parallel edges to very close dimensional tolerances. Common application is sample preparation for tensile testers when running tests on paper, plastic film, foils and other sheet materials. The DT-1010 prepares 1.0 inch or 25 mm wide strips, up to maximum strip length of 10.2 inches. Safety shields are available as an option.
Oakland Instrument also provides sample cutter blade sharpening services.
Contact Oakland for other length and width requirements.
Model DT-1012 Dual-Blade Sample Cutter
The Model DT-1012 is designed to cut sample strips of uniform width. Common application is sample preparation for wider grip-separation testing on tensile testers and for running tests on paper, plastic film, foils and other sheet materials. The DT-1012 prepares 1.0 inch or 25 mm wide strips, up to maximum strip length of 12.2 inches.
Contact Oakland for other length and width requirements.
Model DT-1014 Dual-Blade Sample Cutter
The Model DT-1014 is designed to cut sample strips of uniform width. Common application is sample preparation for Secant Modulus testing on tensile testers and for running tests on paper, plastic film, foils and other sheet materials, where a 10 inch grip separation may be required. The DT-1014 prepares 1.0 inch or 25 mm wide strips, up to maximum strip length of 14.2 inches.
Contact Oakland for other length and width requirements.
|
